Release Guide

MGZT & ROVER 75

(Screwdriver Required)

Under the top silver peak is a thin trim panel, remove this to reveal some screws. Removing these screws will allow access to the radio trim panel, Undo these final screws and the trim will just pop off, allowing access to the screws that hold the radio in. Undo these then release the radio.

ROVER 400

Insert the PC5-83 release keys into holes on each side of radio.

Apply pressure outwards on the keys whilst pulling them towards you.

ROVER 25 - With Allen Key Holes

(3mm Allen Key required)

Insert allen keys into holes on each side of radio. Unscrew them until the radio is loose. Then release the radio.

ROVER MINI

Insert the PC5-83 release keys into holes on each side of radio.

Apply pressure outwards on the keys whilst pulling them towards you.

Get Your Code

Please enter the 14 digit serial number which is located either on a sticker or etched into the side of the stereo.

The Serial number will begin with AL, MG, VD, AR, RG or BP.



Enter the Vehicle Chassis Number (VIN)

The VIN number can be found on your windscreen or printed on the vehicle registration document (log book), this will begin with SARR or SAXX. We only require the VIN number for the EKA Code or Ignition Key Code. If you are retrieving your Radio Code and can not release the radio to locate the serial number you can use just the VIN number. This service is not for Land Rover vehicles.






We require your email address to send an invoice to you
& a copy of your code. View our Privacy Policy here



Hotmail, Yahoo, Gmail & MSN users please
check your junk folder for your code.

Code Is Displayed On The Screen 9am - 11pm GMT

Master Card Accepted HereVisa Credit & Debit Cards Accepted HereSolo Cards Accepted For MG Rover CodesVisa Electron Accepted HereMaestro Accepted HereAdditional Options

Processing Code Request...

One moment please...

Loading Code, Please wait...